Planner & Groover
USAGE:
- Especially developed for high feeding rates -80m/min in high density XPS-boards up to 700 kpa
- Available in hogger kerf up to 1650mm
- Especially suited for multilayer
USAGE:
The Beast Light was developed as a low cost version of our tried and tested The Beast-System. Older installations can benefit of this new technology because of a reduced number of teeth, up to max 40m / min. Feed sufficient. Optimal surface guaranteed without avulsion and melting!
USAGE: Suitable for EPS and PU
The Beast Ultra Light was developed as a low cost version of our tried and tested The Beast-System. Older installations can benefit of this new technology because of a reduced number of teeth, up to 25m / min. Feed sufficient. Optimal surface guaranteed without avulsion and melting!
EINSATZ: Suitable for PU
The Beast PUR was developed as a low cost version of our tried and tested The Beast-System. Older installations can benefit of this new technology because of a reduced number of teeth, up to 35m / min. Feed sufficient. Optimal surface guaranteed without avulsion and melting!
Fritz-Lock (Ultra Lightweight construction)
USAGE:
Tools need to become as lighter as well as durable. This is though contradictory and it cannot always translate into reality. With this cutter, we managed to perfectly combine these qualities and thus an extremely light but also robust milling cutter has been created. The body is slightly above average and weighs only about 3 kg. The cutting edges are connected with the material, with the help of a special glue so firmly, that it is very difficult to release them from the main body.
- Ultra-lightweight tool 5x lighter than steel and 40% lighter than aluminium
Ultra lightweight base made of plastic
Closure system „Fritz-Lock“ Security specifically developed for gluing Technology
Extra strong gel process for the permanent binding
Large chip spaces
Centurio (reversible turn blades system)
USAGE:
- Removable double-sided cutting HSS
- Large chip spaces, thus good chip removal suitable therefore for XPS
- Centrifugal tension of the cutting
- Light body (aluminium)
- More cuts than similar planners (12-18 pieces) therefore better surface
Knife removal/handling
Axial blade change possible
Activate blade tension (centrifugal force assured) 
Changeable two sided cutting edge HSS
Fine hogger Z24 & partial ne machining
USAGE:
- Cutter in complete fine chipping Z24
- For XPS boards 300-700 kpa
- Feed rates up to 35m / min.
- Large boards up to 120mm high
Classic Z18
USAGE:
TCT-shiplap and plane milling cutter sets for simultaneous trimming and grooving of boards. For machines with vertical and horizontal shaft drives.
- With and without fine milling
- Top cutting quality
- Highest durability
- Fine balanced
- Can be individually combined according to customer requests
- Always supplied with suitable tool holding fixture
- Feedrates up to 35 m/min realizable
- Best surface without melting & avulsions up to 500 kpa
Groovers
EINSATZ:
Carbide tipped Groover
Groover with different groove depths and thicknesses, depending on customer requirements
Intermediate rings sanded on both sides for an optimum support & clamping surface
For frequent changes – Intermediate rings with color coding available
Groove saw blades from 0.8 mm width available
Specially realized to avoid meltings